CVT Honda Beat this noisy sound of the solution

Fig 1

His name is any motorcycle, used every day, surely the components will experience wear and damage. If it were so, would not be surprised if later on started causing some complaints. Eg noise or other sounds that are less reassure.

As I experienced on the 2008 Honda Beat. "Early exit from the dealer, no problem. Well after about 1.5 years of my life, came the noise of the CVT. Well, why do it? Subscription service station recommends replacing its roller, as ascertained roller is worn / peyang.

After CVT dismantled, roller peyang and kudu emang been replaced. But after replacement, the sound was still there. "Really really, this time the baseball as hard as before dressing roller. Only the sound when the motor stops / stationary. Although his voice was a bit slow, but make uncomfortable wrote.

Workshop because her customers have not found a solution. I try to come to do Solo Belly Motor. "If this is the case, confirmed the rubber on the roller cover is worn along with the stand. So there is a gap / cavity is rather large, (Fig.1) " Still he said. "Because these devices work open to close or move out as the engine speed, the friction results in wear and tear (Fig.2). Well if the larger sockets, auto-krotok krotok voice also became louder from the hollow part of this. Let his voice be lost, should replace the third rubber. "

Fig 2

Fig 3

Fig 5

Fig 4

Well, if the dealer or auto parts store is still hard rubber replacement nyari this (Figure 3), Hasan took a gap wedge solution with battery tubes. "Although it is replaced with new rubber, if the house is not all roller is replaced, the possibility of noise is still there. Because the flow to pass through the rubber is still worn. Want to know how to prop? Easy, too! "Prepare the battery is still new slang / bending.

Then cut the edges, about 1 cm. Continue to divide the middle wearing a pair of scissors or other tool (Fig.4). If already, lived enter a snippet slang such into part slit / cavity who aus (Fig.5). "It's true! After the three gaps that intersect / friction between the rubber and the grooves fouled slang, noisy sound disappear.